You are here:Home > TRUSS KITS > TKE™ DISPLAY BOOTHS

TKE™ Modular Truss Trade Show Displays

  • Column to Truss
  • Column to Splicer
  •  TK Truss End Base Bracket
  • TK Truss Center Base Bracket

Column to Truss

TKE™ truss displays are simple to assemble, just slide the upper truss bracket into the top of the column slot and tighten the single knob, no tool needed. TKE™ truss sections are built of Aluminum, column to truss sections can be assembles in less than five seconds and are also powder coated in one of Seven Standard Colors, Custom Finish also available. Made in the USA.

Column to Splicer

TKE™ Column to splicer is as simple as it gets, slide the preassembled 36 inch column section in to the lower 44 inch section and tighten the preset set-screws using the Allen wrench which was provided in your kit. This TKE™ system is light weight, highly customizable and can be reconfigured differently for each tradeshow or event you attend. Printed graphic panels are easily attached to this frame using our fabric clip. Many accessories are available for the TKE™ System.

TK Truss End Supports Base Plates

Attaching TKE™ End support plates to Columns require no tool. Simply move the preset slide into position and tighten the two knobs. Attaching TKE™ Center support plates to Columns is also done without tools. Simply move the preset slide into position (one on each side) and tighten the two knobs TKE™ Base plates slide up into columns and require tighten the preset set-screws using the Allen wrench which was provided in your kit. These TKE™ booth kit will normally fit into one rolling reusable case. These Trade Show Booth kits are Highly Customizable and can be reconfigured differently for each show you exhibit.

TKE™ Truss Display Categories